Bosch Appliances DAH94, DAH95 Install Transition, Mount the Hood, Wall Mount, Top Mount, Back

Installation

4. Install Transition

For internal blower installation, install the 7” transition (included) to connect to 7” ducting. If 7” ducting is not available, 8” ducting may be used. In this instance, an additional 7-8” transition must also be used (not included).

For remote blower applications, 10” ducting is required. In this instance, a 7”-10” transition must also be used.

Attach the transition with 4 #8 sheetmetal screws (included) and seal connection with duct tape.

5. Mount the Hood

The DAH model hood can be mounted through the back wall or through the top. See General Information, page 1, for suggestions for hood height.

Once the preferred height is determined, locate the centerline (left to right) of the cooking appliance.

Wall Mount

1.From the centerpoint of the cooking appliance, measure up to the preferred height. Measure up an additional 9” to locate the centerline of the screw holes (see Figure 4).

2.Install toggle bolts through drywall leaving 1/4” of the bolt exposed.

Install one togglebolt 11 1/2” to the left of the centerline and one togglebolt 11 1/2” to the right of the centerline. These are the only installation points for the 30” hood. See Figure 4

For the 36” hood, there are 2 additional installation points. These are also at the centerline height, but are 15 3/8” from the centerline in each direction.

See Figure 4.

3.Place the hood by sliding the mounting holes in the hood over the bolts.

4.Tighten the bolts.

Top Mount

1.Install the hood flush against the back wall.

2.Identify the centerline on the mounting surface (underside of cabinet).

3.Place the hood and install the drywall screws through the mounting holes.

Insert 3 drywall screws 11 1/2” off the centerline in both directions at the following depths:

1.2 1/4” from the back wall

2.8 1/4” from the back wall

3.9 1/4” from the back wall

(See Figure 5).

The 36” hood also requires 3 additional screws, at the same depths, on each side (total of 6). These

are 15 3/4” from the center line (See Figure 5).

4.Place the hood.

5.Tighten the screws.

Figure 4 - Wall Mount

C L

15-3/8"

from CL

9"

11-1/2"

from CL

30" - 36"

Figure 5 - Top Mount

CL

TopFrontMount

1"

6"

2 1/4"

Back

4