Bosch Appliances DX4010I DX4010i | Installation Instructions | 4.0 Wiring

DX4010i Installation Instructions 4.0 Wiring

4.0 Wiring

Remove all power to the control panel (AC and standby battery) before making or breaking any connections. Failure to do so can result in personal injury or damage to the equipment.

Wire Length Restrictions

•0.8 mm (#22 AWG): 305 m (1000 ft)

•1.2 mm (#18 AWG): 610 m (2000 ft)

SDI wiring is limited to 305 m (1000 ft).

Connect the DX4010i to the control panel data and auxiliary power sources as shown in Figure 2.

Figure 2: Control Panel Connections

1	2
B	3
G	4
Y	5
R	6

Figure 3: External Power Supply Connections

1	2
	3
	4
	5
	6
+	-
	7

1- DX4010i data bus

2- Control panel data bus

3- Option AUX common/SDI common (black)

4- Option data/SDI B (green)

5- Option data/SDI A (yellow)

6- Option AUX power +/SDI power (red)

7- External 12 VDC power supply

Figure 4 shows serial device-to-DX4010i connections using the DB9 DTE RS-232 connector (P6).

Figure 4: Serial Device Connections

1- DX4010i data bus

2- Control panel data bus

3- Option AUX common/SDI common (black)

4- Option data/SDI B (green)

5- Option data/SDI A (yellow)

6- Option AUX power +/SDI power (red)

If an external 12 VDC power supply is used, wire as shown in Figure 3.

Rx Tx	Tx Rx
BUS		SER

P3

LED

ENABLE

P2

P6

P1

DB9 GND

ENABLE

1

1- Serial (RS-232) device such as a PC (with RPS, BIS, PC9000, or other third party application) or a serial printer for supported control panels.

See Section 7.0 DB9 DTE RS-232 Connector (P6) on page 10 for additional information.

Figure 5 shows a parallel printer connected to the serial output of the DX4010i. This type of connection requires the use of a serial to parallel converter, such as the BlackBox PI045A serial to Centronics parallel converter cable. The cable is available from BlackBox® (www.blackbox.com).

Bosch Security Systems, Inc. 1/05 4998141106C 5