Bosch Appliances FPA-1200-MPC-C manual Functional Description, Installation, Wiring

MPC-xxxx-C / FPA-1200-MPC-C en 17

WARNING!

Live components and stripped cable! Risk of injury from electric shock. The system must be current-free during connection work.

NOTICE!

Installation must only be performed by authorized and specialized personnel!

NOTICE!

The CD includes the FSP-5000-RPS Programming Software and the required product documentation of the panel.

Functional Description

The Panel Controller controls every component connected to the panel and features the following functional elements (see Figure 1, Page 4):

Pos.	Designation	Function
A	Touch screen	Operating the panel through virtual buttons and variable display windows
B	22 fixed buttons	Standard entries
C	11 LEDs	Indicating the operating status
D	Key switch	2 switch settings, freely programmable, e.g. for switching between day/
		night mode, or connection/disconnection to and from the local alarm
		signaling
E	3 rotary switches	Address setting
F	Reboot button	Panel HW reset
G	6-pin DIP switch	Configuration
H	Ground wire	Grounding the panel

Installation

The FPA-1200-MPC-C Panel Controller is only used with the FPA-1200 Fire Panel.

The MPC-XXXX-C Panel Controller may be mounted into the following FPA-5000 housings: CPH 0006 A, MPH 0010 A, HCP 0006 A and HBC 0010 A.

For the installation, follow the instructions given in Figure 2 to Figure 4 (Page 5 to Page 7):

1.Make sure that the PRS 0002 A Panel Rail Short is mounted before you start installing the Panel Controller.

2.Connect the ground wire to the screw on the housing (Step 4, Figure 3, Page 6).

3.Plug the cable into the slot labeled "IN" of the PRS 0002 A Panel Rail Short (Step 6, Figure 3, Page 6).

Note: Do not plug the cable into the slot labeled "OUT" nor into the slots of the PRD 0004 A Panel Rail Long.

4.Plug the EOL resistor for the databus into the slot labeled "OUT" of the last panel rail PRS/PRD in use (Step 8, Figure 4, Page 7).

Wiring

The Panel Controller features

-2 CAN interfaces (CAN1/CAN2) for networking

-2 Ethernet interfaces (ETH1/ETH2) for networking

-2 signal inputs (IN1/IN2)

-1 USB and 1 RS232 interface

Consider the maximum cable length of 2 m when using the USB and RS232 interfaces (see Figure 5, Page 8).

NOTICE!

You will find detailed information about the CAN and Ethernet networking of the panels in the Networking Guide available for download at www.boschsecurity.com.

Bosch Sicherheitssyteme GmbH F.01U.258.925 2.0 2012.04