Bosch Appliances HBN33, HBL8750 Testing Operation, Installing the Oven, To replace the oven door

Installing the Oven	1. Lift or slide unit into cabinet cutout. Do not lift appliance by door handle.
	2. Push straight in until oven trim is flush with cabinet wall, being careful not to
		crimp flexible conduit between oven and cabinet back wall. The oven should be
		straight and level, not crooked.
	3. Install supplied screws through tap holes in trim. (2 screws for single ovens, 4
		screws for double/combo ovens)
	To replace the oven door:
			1.	Holding the door firmly in both hands,
				place hinges in hinge slots.
			2.	Open door all the way to expose
				hinges and slots.
			3.	Push lever down and away from you
				until flush with the bracket.
			4.	Close and open door slowly to be sure
				it is correctly and securely in place.
				Door must be straight, not crooked.

Testing Operation

1.Turn on power at the breaker.

2.Check power at junction box using a volt meter.

For 240 V installation, the reading between the red and black wires (line to line) should be 220 to 240 volts.

For 208 V installation, the reading between the red and black wires (line to line) should be 190 to 208 volts.

3.Test the oven mode.

Select the BAKE mode. See the Use and Care Manual for detailed operation instructions.

4.Verify that the oven light comes on and the oven begins to preheat.

5.Test the door lock.

Set the SELF CLEAN mode. Confirm that the door locks when the lock icon appears in the display.

6.If installing a double oven, test the second oven as well.

7.If any of the tests do not result as explained above, contact Thermador service for assistance. Otherwise, the installation is complete at this time.

English 15