Bosch Appliances LTC9412/00 installation manual Exploded View, Description Part number

LTC9412/00

Instruction Manual Installation

EN

3

4.6.Remove the set screw and drill an approximately 7/32" hole at the point where the set screw dimples the conduit. Remove the burrs and replace the set screw.

4.7.Attach the longer arm of the camera bracket to the end of EMT connector using the clamp nut. Tighten (Figure 3).

5 EXPLODED VIEW

A

B

C

Figure 3 Attach bracket arm to EMT connector

4.8.Attach the other bracket arm using a carriage bolt, 5/16” washer, lockwasher, and hex nut. The camera mounting side may be facing either in or out (Figure 4).

D

E

F

G

Figure 4 Attach other bracket arm

4.9.Connect the camera to the camera bracket and adjust to desired viewing position. Tighten all connections. Complete wiring of the camera.

4.10.Place the liner inside the dome. Hold the dome and liner up to the housing and align the 3 Hartwell Fasteners in the dome to the matching holes on the housing. Ensure that the cutout in the liner is aligned with the camera. Once it’s correctly positioned attach the dome to the housing by pressing the Hartwell Fasteners into the flange of the dome (Figure 5).

Hartwell Fasteners

Figure 5 Attach the dome to the housing

	Description		Part number		Qty.
A	Clamp connector		70-WPCR02		1
B	12" ABS housing (black)		21-TOP123		1
C	EMT connector		70-WPCR01		1
D	Camera bracket		30-VL1361		1
E	12" dome liner		20-LNOP123		1
F	Hartwell fastener		95-FSPLO1(2)		3
G	12" OP clear dome		RCOP123		1
		A		F
		B
		C			G
		D			H
		E			I
		Description		Qty.
	A	VL1361 bracket		1
	B	1/4-20 hex nut		1
	C	1/4" split lockwasher		1
	D	1/4" flat washer		1
	E	FM2 bracket		1
	F	5/16" washer		1
	G 1/4-20 x 3/4" carriage bolt			1
	H 1/4-20 x 1/2" hex bolt			1

Bosch Security Systems 14 November 2003