LTC 2821/91 Instruction Manual Controls & Connections | EN 10 |
|
|
5.2Rear Panel
See FIGURE 2 for location of rear panel connectors.
VIDEO LINE
VIDEO A IN/OUT
IN: Video signal input terminal.
OUT: Passive
NOTE: For corresponding audio signal, use the AUDIO A terminals.
VIDEO B IN/OUT
IN: Video signal input terminal.
OUT: Passive
NOTE: For corresponding audio signal, use the AUDIO B terminals.
VCR IN: Video signal input terminal.
NOTE: For corresponding audio signal, use the AUDIO IN VCR terminal.
AUDIO LINE
AUDIO A IN/OUT
IN: Audio signal input terminal.
OUT:
NOTE: For corresponding video signal, use the VIDEO A terminals.
Figure 2: Location of Rear Connectors
AUDIO B IN/OUT
IN: Audio signal input terminal.
OUT:
NOTE: For corresponding video signal, use the VIDEO B terminals .
AUDIO IN VCR: Audio signal input terminal.
NOTE: For corresponding video signal, use the VCR IN terminal .
AC IN
Power input connector. Connects the supplied AC power cord to the appropriate AC outlet.
NOTE:
The impedance is automatically set to 75 ohms by the input of a signal on the input connector while operating in a single connection mode.
However, if a cable is connected to the output connector, the connection is placed into the open status by the multiple connection and high impedance automatically selected. Do not leave an unused cable connected to the monitor. If a single cable is used, then it must be connected to the input connector for the 75 ohms auto termination selector to function properly.
