Bosch Appliances MON170CL instruction manual Connecting the Y/C S-video Signal to the Monitor

MON170CL Instruction Manual Installation

5.4Connecting the Y/C (S-video) Signal to the Monitor

There is one (1) mini-DIN type connector for the S-video (Y/C) input (see Figure 2 and Figure 3 below).

NOTE: Both Y and C inputs are terminated with 75

4	3		1. GND
			2.	GND
			3.	Y-signal IN
2		1	4.	C-signal IN

Figure 3: Y/C Connection Pinout

5.5Connecting Audio to the Monitor

There is one (1) set of mini phone jack for the audio connector (Figure 2 and Photo F).

Photo F

5.6Connecting the Analog VGA Signal

to the Monitor

There is one (1) 15-pin D-sub connector (Figure 4) for one analog VGA input. Refer to Figure 2, item B.

Figure 4: Analog VGA Connector

EN 9

5.7VESA Standard Mounting Hole (For

Wall-mount Use)

1.Carefully press the cover and remove it from the stand. (as shown in photo G)

2.Unscrew the three holdings screws hidden under the high cover before separating the stand from the panel. (as shown in photo H)

3.The square mounting hole patterns are VESA standard on 100 mm (3.9 centers, as shown in photo I). Mount the unit to mounting device using the four mounting holes on the rear panel.

Photo G

Photo H

Photo I

Bosch Security Systems 6 July 2005