Installation Instructions | Models: NES 730, NES 930 |
Solid Surface Countertops | H | |||
Always | consult | the | countertop |
|
manufacturer for specific instructions.
Countertops made from natural (i.e. granite and marble) or SOLID SURFACE MATERIALS, such as Surell™ and Corian®, require special cutout preparation and installation procedures. Follow the guidelines below and on pages
Install the cooktop as follows:
1.Round the cutout corners according to instructions from the countertop manufacturer.
2.Apply heat reflective tape (such as Scotch® Aluminum Foil Tape #425 or #427) around the cutout so that it folds over the top and side surfaces. Be sure the tape extends beyond the outermost flange of the cooktop. All corners should also be covered with tape.
3.Attach brackets to the burner box using washers and screws provided. Use a wooden block underneath the countertop before tightening the bracket screws.
4.Center cooktop in the cutout to ensure adequate clearance between the burner box and countertop edge. (A light pencil mark along the center of front edge and side edge of cooktop and counter will aid in the positioning of the cooktop in the center.)
5.Trim excess aluminum tape from along the frame edges.BE CAREFUL not to scratch the countertop.
ELECTRICAL CONNECTION
1.Attach flexible conduit to the junction box.
2.Connect the cooktop lead wires to the junction box supply wires in proper phase:
For all models, connect black (L1) to black, red (L 2) to red, white wire to neutral and green wire to ground.
NOTE: If the cooktop is installed and connected as specified above, it will be completely grounded in compliance with the National Electrical Code.
3.Remove everything from the cooktop surface and apply Cooktop Cleaning Creme (packaged with cooktop) as directed in Use & Care Manual, Page 9.
4.Turn on power supply.
5.Test operation.
NOTE: Your cooktop surface needs to be cleaned daily. Refer to the Use and Care section before using it for the first time.
PAGE 5
