14 en Installation | Power Supply |
|
|
2.4Connecting the input cable
5mm (0.2 in)
Input
50/60 Hz
Neutral In | Live In |
| Earth In |
Figure 2.3 Connecting the input cable
Connect input supply cable as follows:
–Cut back the insulation of the cable wires to approximately 5 mm (0.2 in).
–Pass the input cable through the supplied grommet.
–For each wire, push back the tab behind the terminal with a small screwdriver and insert the wire (respect the polarity shown in the figure); release the tab to clamp the wire in place.
–Secure the grommet firmly.
–Return the protective cover to its position and fasten in place with the four
Note:
Tighten screws firmly to ensure protection against water ingress.
Installation manual | Bosch Security Systems |