Power Supply | Installation en 15 |
|
|
2.5Connecting the output cables
5mm (0.2 in)
24 V 24 V 0 V 0 V
Figure 2.4 Connecting the output cables
Connect the two output cables as follows:
–Cut back the insulation of the cable wires to approximately 5 mm (0.2 in).
–Pass the output cables through the supplied grommets.
–For each wire, push back the tab behind the terminal with a small screwdriver and insert the wire (respect the polarity shown in the figure); release the tab to clamp the wire in place.
–Secure the grommets firmly.
–Return the protective cover to its position and fasten in place with the four
Note:
Tighten screws firmly to ensure protection against water ingress.
Bosch Security Systems | Installation manual |
