RADIO RECEPTION
MANUAL TUNING
1
POWER
2 | MODE | |
BAND | ||
|
1 Press TUNER/BAND repeatedly to select the desired band.
FM 
AM 
When TUNER/BAND is pressed while the power is off, the previously tuned station will be played (Direct Play Function).
To select a band with the remote control
Press BAND repeatedly.
2Press for gto select a station.
Each time the button is pressed, the frequency changes. When a station is received, “TUNE” is displayed for 2 seconds. During FM stereo reception, “1” is displayed.
TUNE 1
To search for a station quickly (Auto Search)
Keep f or g pressed until the frequency starts to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press for g.
•The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press MODE on the remote control so that “MONO” appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again so that “MONO” disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.
Press POWER while pressing TUNER during power on. To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are cleared. The preset stations have to be set again.
7 ENGLISHPRESETTING STATIONS
dDIR/
PRESET
1
s
2 | |
| |
1 | BAND |
|
The unit can store a total of 32 preset stations (Each band has a maximum of 20 available preset stations). When a station is stored, a preset number is assigned to the station. Use the preset number to tune in to a preset station directly.
1Press TUNER/BAND to select a band, and press for gto select a station.
2Press ato store the station.
A preset number beginning from 1 in consecutive order for each band is assigned to the station.
Frequency | Preset number | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations for all the bands or a total of 20 preset stations for one band have already been stored.
PRESET NUMBER TUNING
Use the remote control to select the preset number directly.
1Press BAND to select a band.
2Press numbered buttons 0-9 and +10 to select a
preset number.
Example:To select preset number 10, press +10 and 0.
To select preset number 15, press +10 and 5.
Selecting a preset number on the main unit
Press TUNER/BAND to select a band. Then, press d DIR/ PRESET repeatedly.
Each time d DIR/PRESET is pressed, the next ascending number is selected.
To clear a preset station
Select the preset number of the station to be cleared. Then, press s, and press awithin 4 seconds.
The preset numbers of all other stations in the band with higher numbers are also decreased by one.
7 | 10/4/2000, 5:07 PM |
