Aiwa XR-M150 Setting The Clock, Setting The Sleep Timer, 1Press DISPLAY on the remote control

CLOCK AND TIMER

SETTING THE CLOCK

VOL/

MULTI JOG

s

2

1

DEMO/ECO

2

1Press DISPLAY on the remote control.

To set the clock during power off, press a until the clock

is displayed.

2Within 4 seconds, press for gto designate

the time, then press a.

Each time f or g is pressed, the time changes by 1 minute. To change the time by 30 minutes, press and hold

for g.

•VOL/MULTI JOGis also available instead of fand g.

To display the current time

With power on, press DISPLAY once on the remote control. The time is displayed for 4 seconds.

However, the time cannot be displayed during recording. When the power is off, press DEMO/ECO repeatedly until the display changes to clock.

To switch to the 24-hour standard

With power on, press DISPLAY once on the remote control then press swithin 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

SETTING THE SLEEP TIMER	RECORDING
VOL/
MULTI JOG	TIMER
2
	AND
1
	CLOCK

The unit can be turned off automatically at a specified time.

1Press SLEEP.

SLEEP

2Within 3 seconds, press f or g to specify

the time until the power is turned off.

The time changes between 5 and 240 minutes in 5-minute steps.

•VOL/MULTI JOG is also available instead of fand g. En

Specified time

To check the time remaining until the power is turned off

Press SLEEP once. The remaining time is displayed for 4 seconds.

To cancel the sleep timer

Press SLEEP twice so that “SLEEPoFF” appears on the display.

ENGLISH 14

09-14/XR-M150<U>/Eng 14 10/4/2000, 5:09 PM