Bosch Appliances sHX33M, sHe42l, sHX43C To Remove the Large Object Trap/Cylinder Filter Assembly

under the lower rack and is easily accessible.

During normal use, the filter system is self-cleaning. You should occasionally inspect it for foreign objects and clean it when necessary.

To Remove the Large Object Trap/Cylinder Filter Assembly:

1.Remove the bottom rack.

2.Grasp the assembly as shown in Figure 28 and turn it counter- clockwise 1/4 turn.

3.Lift out the assembly as shown in Figure 29.

4.Carefully examine the assembly. If you find debris in the Large Object Trap, turn it upside-down and gently tap it on a surface such as a countertop to dislodge and remove the debris. Flush the Cylinder Filter clean by holding it under running water.

To Remove the Fine Filter:

1. Lift the Fine Filter from the dishwasher floor as shown in Figure 30 and flush it clean by holding it under running water.

To reinstall the filter system:

1.Return the Fine Filter to its installed position.

2.Place the Large Object Trap/Cylinder Filter Assembly into its installed position in the dishwasher floor.

3.Turn the ring handle clockwise 1/4 turn until it is locked. The arrow

on the ring handle and the arrow on the Fine Filter should point to each other, as shown by the circle in Figure 31.

4.Gently pull the ring handle to ensure that the assembly is locked into place.

ATTENTION

To avoid possible diswasher damage, do not use harsh chemicals, abrasive cleaners, scouring pads (metal or plastic), or abrasive cloths/paper towels to clean your dish- washer’s exterior door panel. Your dishwasher’s exterior door panel can be damaged by doing so.

Figure 28

To open - turn counterclockwise.

Figure 29

Large Object Trap/Cylinder Filter

Figure 30

Fine

Filter

Figure 31

To close - turn clockwise.

17