Rinse Agent Dispenser

Open the rinse agent dispenser by lifting the tab with your thumb as shown in Figure 17.

NOTE: The dishwasher indicates low rinse agent either by showing the symbol in the countdown display, or illuminating the refill rinse agent light (model dependent).

Add liquid rinse agent to the dispenser as shown in Figure 18 until the rinse agent reservoir is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.

NOTE: After filling the rinse agent dispenser, the indicator light will go out in a few minutes after the dishwasher door is shut (select models only).

Operating the Dishwasher

Always make sure your dishware is dishwasher safe. Refer to the Dishware Materials section of this manual for guidance.

Wash Cycles (See Cycle Chart)

Power Scrub Plus

Cleans items having baked-on or hard dried-on food soils. These items may require soaking or hand scouring.

Regular

Thoroughly cleans large loads having loosely attached normal soiling.

Delicate/Economy

For delicate or heirloom dishwasher and silverware or other special items. Always make sure that the items are dishwasher safe. Refer to the Materials section of this manual for further information. Hand washing may be the best treatment of such items.

Quick Wash

For lightly soiled items with easy to remove food soils.

Rinse and Hold

Allows you to rinse the food soil off of a partial load and hold them in the dishwasher until there is a full load.

Wash Cycle Options

Half Load

In the Power Scrub Plus, Regular and Auto Wash cycles you can reduce the energy and water consumption when washing small, lightly soiled loads that fill approximately half of the dishwasher’s capacity. To activate, select the Half Load button in addition to the Power Scrub Plus, Regular or Auto Wash cycle button.

The Cycle Completion Signal (select models)

This Cycle Completion Signal is a tone that sounds to alert you when your dishwasher finishes washing and drying your dishes. You can either disable the tone or set the volume.

To activate:

·Press and hold the right “Cancel Drain” button then press and hold the On/Off button.

·When the light on the “Cancel Drain” button you are pressing illuminates and the tone begins to sound, release both buttons.

·Press the right-most “Cancel Drain” button until the tone is either at the desired volume or is silent.

·Press the On/Off Button. The Cycle Completion Signal is now set.

 

 

 

Wash Cycles

 

 

 

 

 

 

 

 

 

 

 

 

Power Scrub Plus

Regular

Delicate/Economy

Quick Wash

Rinse and Hold

Half Load

 

 

 

 

 

 

 

SHE43C

x

x

x

 

x

 

 

 

 

 

 

 

 

SHX43C

x

x

x

 

x

 

 

 

 

 

 

 

 

SHU33A

x

x

 

 

x

 

 

 

 

 

 

 

 

SHX33A

x

x

 

 

x

 

 

 

 

 

 

 

 

SHE42L

x

x

x

x

 

 

 

 

 

 

 

 

 

SHX36L

x

x

x

x

 

x

 

 

 

 

 

 

 

SHX33M

x

x

 

 

x

 

 

 

 

 

 

 

 

SHE33M

x

x

 

 

x

 

 

 

 

 

 

 

 

 

13

Page 10
Image 10
Bosch Appliances sHX43C, sHe42l, sHX33M manual Operating the Dishwasher, Wash Cycles See Cycle Chart, Wash Cycle Options