Operating the Dishwasher
Selecting the Proper Wash Cycle
Items with
The Regular Wash cycle will thoroughly clean large loads having loosely attached normal soiling.
The Rinse and Hold cycle will allow you to keep a small load in your dishwasher until you have enough items for a full load.
To avoid damage to delicate or heirloom items do not wash them in your dishwasher.
For delicate or heirloom dishware and silverware, or other special items, select Delicate/Econo after referring to the Materials section of this manual.
More information on dishwasher cycles is in the Wash Cycle Information section of this manual.
Starting the Dishwasher
Shut the dishwasher door.
Press the On/Off button.
Press the button for the desired wash cycle.
The dishwasher will start automatically and continue operating until the end of the selected cycle.
Once you start the dishwasher, leave the dishwasher door shut until it finishes the cycle.
Interrupting a Cycle
NOTE: Should you need to interrupt a cycle (to add or remove an item, to add detergent, etc.), it is best to do so within the first 30 minutes of the cycle.
Press the On/Off button.
WARNING
You could be seriously scalded if you open the dishwasher door quickly during a wash or rinse cycle. Do not fully open the dishwasher door for at least 10 seconds or until water noises stop.
Wait at least ten seconds or until water noises stop before opening the dishwasher door.
To resume the cycle, shut the dishwasher door and press the On/Off button.
Canceling or Changing a Cycle
To cancel or change a cycle, press and hold for three seconds the two buttons labeled “Cancel Drain” as shown in Figure 22.
Figure 22
Cancel Drain 
Wait approximately one minute, then press the On/Off button.
You may now begin a new cycle.
11
