Figure 25
To open - turn counterclockwise.
Figure 26
Large Object Trap/Cylinder Filter
Figure 27
Fine
Filter
Figure 28
Micro
Filter
Check/Clean the Filter System
This dishwasher has a filter system that consists of a Large Object Trap/Cylinder Filter assembly and a Fine Filter. Select models have an additional Micro Filter. The filter system is located on the inside of your dishwasher under the lower rack and is easily accessible.
During normal use, the filter system is
CAUTION
To avoid injury, do not reach into the large object trap with your fingers. The large object trap could contain sharp objects.
To Remove the Large Object Trap/Cylinder Filter Assembly:
1.Remove the bottom rack.
2.Grasp the assembly as shown in Figure 25 and turn it counter- clockwise 1/4 turn.
3.Lift out the assembly as shown in Figure 26.
4.Carefully examine the assembly. If you find debris in the Large Object Trap, turn it
To Remove the Fine Filter:
1.Lift the Fine Filter from the dishwasher floor as shown in Figure 27 and flush it clean by holding it under running water.
2.Remove the Micro Filter as shown in Figure 28 and flush it clean by holdin git under running water.
To reinstall the filter system:
1.Return the Fine Filter to its installed position.
2.Place the Large Object Trap/Cylinder Filter Assembly into its installed position in the dishwasher floor.
3.Turn the ring handle clockwise 1/4 turn until it is locked. The arrow
on the ring handle and the arrow on the Fine Filter should point to each other, as shown by the circle in Figure 29.
4.Gently pull the ring handle to ensure that the assembly is locked into place.
ATTENTION
To avoid possible dishwasher damage, do not use harsh chemicals, abrasive cleaners, scouring pads (metal or plastic), or abrasive cloths/paper towels to clean your dish- washer’s exterior door panel. Your dishwasher’s exterior door panel can be damaged by doing so.
16
