_12.
RINSE AGENT DISPENSER REGULATOR
The rinse agent reservoir of the Bosch dishwasher is provided with a regulator calibrated from 1 to 6. See Figure 13. This regulator controls the amount of rinse agent dispensed. The dishwasher leaves the factory preset to 3_AThis. has been chosen as the average setting, however:
Indicator
Dosage Control
_13.
•if you see streaks, it is recommended that the regulator be turned to a lower number.
•if water spots appear, it is recommended that the regulator be turned to a higher number.
TO ADJUST SETTING:
•Open the cover of the rinse agent dispenser.
•Turn the setting indicator to the desired setting. See Figure 13.
RINSE AGENT INDICATOR
There is a level indicator on the dispenser, see Figure 11 and 13. This indicator shows the level of rinse agent that is in the rinse agent reservoir. As received, and when empty, the level indicator on the dispenser will appear blank.
When the rinse agent reservoir is full the level indicator on the dispenser will appear dark.
The Bosch SH'q 4800 series is also equipped with a indicator light on the control panel. The light will illuminate when it is time to refill the rinse agent reservoir.
CYCLE SELECTION
The dishwasher will wash and dry the contents based on cycle selection made. Refer to the CYCLE SELECTION CHART, Table 2. The most appropriate cycle for the load to be washed can be selected from this table by comparing the load type and the amount and condition of the food on the items to the charts recommendations.
OPERATION
TO START THE SHU 3300, SHU 4300 and SEll 4300
Once detergent has been added and before closing the door of the dishwasher check the wash arms to ensure
that they are free to move. With the detergent in the dishwasher and arms free to move:
•Close the door of the dishwasher making sure that door latches dosed.
•Depress the on/off switch. The indicator light for the cycle that was last selected will become illumina_wxt.
•Depress the button for the cycle you desire TWO TIMES if it is different than the illuminated cycle.
•The dishwasher will start automatically and continue to the end of the selected cycle. The cycle
progress lights, to the fight of the cycle buttons, will become illuminated to show where dishwasher
is in cycle.
•At the end of the cycle the dishwasher will stop and the "CLEAN" light will become illuminated.
TO INTERRUPT OR RESET CYCLE
To interrupt cycle simply depress the on/off button to stop operation. If you are interrupting the cycle during a wash or rinse cycle please wait until the water noises stop before opening the door. After opening the door leave it ajar for a few minutes. The cycle then may be
resumed by closing the door and depressing the on/off button.
As a safety feature the dishwasher will automatically turn itself off whenever the door is unlatched.
However, if the door is opened quickly while in a
wash or rinse cycle some water may splash out of the dishwasher. For this mason it is recommended that the
machine always be switched to off before opening the door.
10
