Bosch Appliances SHX43E manual Look for obstruction in the spray nozzles

3.Return the top rack to the top rack roller guides. To remove the bottom spray arm:

1.Remove the empty bottom rack from the dishwasher tub.

2.Grasp and lift the bottom spray arm as shown in Figure 27.

3.Look for obstruction in the spray nozzles.

4.If the spray nozzles need cleaning, flush them under running water. To reinstall the bottom spray arm:

1.Return the bottom spray arm to its installed position and press it so that it snaps into place.

2.Return the bottom rack to its installed position.

Check/Clean the Filter System

This dishwasher has a filter system that consists of a Large Object Trap/Cylinder Filter assembly and a Fine Filter. Select models have an additional Micro Filter. The filter system is located on the inside of your dishwasher under the lower rack and is easily accessible.

During normal use, the filter system is setf-cleaning. You should occasionally inspect it for foreign objects and clean it when necessary.

,CAUTION

To avoid injury, do not reach into the large object trap with your fingers. The large object trap could contain sharp objects.

This dishwasher has a filter system that consists of a Large Object Trap/Cylinder Filter assembly and a Fine Filter. The filter system is located on the inside of your dishwasher under the lower rack and is easily accessible.

During normal use, the filter system is setf-cleaning. You should occasionally inspect it for foreign objects and clean it when necessary.

To Remove the Large Object Trap/Cylinder Filter Assembly:

1.Remove the bottom rack.

2.Grasp the assembly as shown in Figure 28 and turn it counter- clockwise 1/4 turn.

3.Lift out the assembly as shown in Figure 29.

4.Carefully examine the assembly. If you find debris in the Large Object Trap, turn it upside-down and gently tap it on a surface such as a countertop to dislodge and remove the debris. Flush the Cylinder Filter clean by holding it under running water.

To Remove the Fine Filter:

1.Lift the Fine Filter from the dishwasher floor as shown in Figure 30 and flush it clean by holding it under running water.

To reinstall the filter system:

1.Return the Fine Filter to its installed position.

2.Ptace the Large Object Trap/Cylinder Filter Assembty into its instalted position in the dishwasher floor.

3.Turn the ring handle clockwise 1/4 turn until it is locked. The arrow

on the ring handle and the arrow on the Fine Filter should point to each other, as shown bythe circle in Figure 31.

4.Gently pull the ring handle to ensure that the assembly is locked into place.

ATTENTION

To avoid possible diswasher damage, do not use harsh chemicals, abrasive cleaners, scouring pads (metal or plastic), or abrasive doths/paper towels to clean your dish- washer's exterior door panel. Your dishwasher's exterior door panel can be damaged by doing so.

Figure 28

To open - turn counterclockwise.

Figure 29

Large Object Trap/Cylinder Filter

Figure 30

Figure 31

To close - turn clockwise.

17