Installation,
Connection
and Transportation
FactoryCsupplied equipment
There is a packet of accessory parts supplied with your washer. Check to make sure that all th accessory parts supplied for your model are ther If any parts are missing contact your dealer immediately.
Inside the drum:
Safety information
CAUTION
Avoid risk of injury!
The washing machine is heavy. Lift with caution.
CAUTION
Frozen hoses can tear/burst. Do not install the washing machine outdoors or in an area exposed to frost.
Be sure to observe all listed warnings and cautions.
These installation instructions are intended for use
by qualified installers. In addition to these | - Water supply hoses (cold and hot water). |
| |
instructions the washer shall be installed: | Any dampness left inside the drum was caused |
-In the United States, in accordance with the the final testing which every washing machine is National Electric Code, ANSI/NFPA70 ~ latest subject to before leaving the factory. edition/State and Municipal codes and/or local
codes.
-In Canada, in accordance with the Canadian Electric Code C22.1 ~ latest edition/State and Municipal codes and/or local codes.
If the washing machine is stored in a room which will be exposed to temperatures below the freezing point, or if it is located in a cabin that is being shut down for the winter, any residual water in the pump or water inlet hose(s) must be drained.
To drain the pump refer to page 20.
To drain the water hose(s) refer to page 22.
Take care not to damage the washing machine. Do not hold onto protruding parts (e.g. loading door) when lifting.
In addition to the safety information listed here, the local water and electricity supplier may have special requirements.
In case of doubt, have the appliance connected by an authorized technician.
26
