Start the tool before applying to work and let the tool come to full speed before contacting the workpiece. Lift the tool from the work before releasing the switch. DO NOT turn the switch “ON” and “OFF” while the tool is under load; this will greatly decrease the switch life.
Grinding Wheels
WARNING! Before using a grinding wheel, be certain that its maximum safe operating speed is not exceeded by the nameplate speed ofthegrinder. Donotexceedtherecommended wheel diameter.
Grinding wheels should be carefully selected in order to use the grinder most efficiently. Wheelsvaryintypeofabrasive,bond, hardness, grit size and structure. The correct type of wheel to use is determined by the job.
Installing Accessories
CAUTION! Be sure that the diameter of the shank is the same size as the inside diameter of the collet.
Models 1209, 1210 & 1215 are equipped with a 1/4" collet.
(Models 1209 & 1215)
1.Place the (22mm) spindle lock wrench that is provided onto the spindle to prevent the spindle from rotating.
2.Hold wrench in place and rotate collet nut 1
3.Insert three fourths of shank of accessory into the collet, and securely tighten with the wrench provided.
NOTE: When replacing collets on the model 1215, loosen the collet nut and remove together with collet 6, then screw in new collet.
Removing Accessories
Repeat steps 1 and 2 of above and remove accessory.
Installing Accessories
(Model 1210)
1.Insert the locking pin provided into hole in the spindle, to prevent the spindle from rotating.
2.Hold locking pin in place and rotate collet nut
1
3.Insert three fourths of shank of accessory into the collet, and securely tighten with the wrench provided.
Removing Accessories
Repeat steps 1 and 2 of above and remove accessory.
Guard Installation (Model 1214 only)
1.Loosen guard mounting strap nuts 10, and the wing nuts 7 on guard cover 8.
2.Place wheel guard 9 over spindle and positon guard mounting strap on lip of the machined spindle housing.
3.Rotate guard 9 into position where maximum protection is provided for the operator from spark and debris, then tighten mounting strap nuts 10.
7
8
GRINDING
WHEEL
Installing Grinding Wheel
( Model 1214 only)
Your tool uses grinding wheels 5" maximum diameter by 1" thick.
1.Insert the locking pin into the hole in the inner flange 11 to prevent the spindle shaft from rotating.
2.Hold locking pin in place and rotate nut 13
9
12
10
1113
7
BM 3609929341 12/03 | 7 | 12/16/03, 11:40 AM |
