The ideal temperature should first be ascer- tained by performing a test. You should there- fore start with a low temperature setting. The temperatures specified in the illustrated ex- amples of use are recommended values which can vary depending on the properties of the workpiece. The distance between the nozzle and workpiece is dependent on the material to be processed. Additional information can be found in popular DIY books or consult the manufacturer of the heat activated product.
NOTE: The 1100ºF(595ºC) setting can not be reached on full air flow setting. If 1100ºF(595ºC) is required, reduce setting on blower speed dial 3 until 1100ºF(595ºC) is indicated on LED temperature display 4.
Bosch stocks a range of accessories (see cata- log) which offer a wide range of other applica- tions.
The sections indicated by capital letters in the instructions for use below refer to the illustrated examples of use in this manual.
ARemovingpaint/dissolvingadhesives
Fit the flat nozzle. Soften the paint using hot air and remove evenly using a scraper. Do not heat the paint for too long since this will burn the paint, making it more difficult to remove. To carry out work in confined spaces, remove the heat shield. Many adhesives (e.g. stickers) be- come softer when heated, allowing adhesive bonds to be separated and adhesive to be re- moved.
BRemoving paint or caulking from windows
Glass can break easily. Always use the glass deflector nozzle. On profiled surfaces, paint can be removed using a scraper and brushed off using a soft wire brush.
DDefrosting water pipes
Fit the reflector nozzle. Always heat the frozen area inwards from the edge to the center.
CAUTION! Do not attempt to defrost PVC piping.
Note: Water pipes are often difficult to distin- guish from gas pipes. Copper pipes are joined using tin and should therefore not be heated above 392ºF (200ºC).
C
Shrink fitting electrical connections
Fit the reflector or reducing nozzle. Select a
7
BM 2610910610 9/01 | 7 | 10/4/01, 10:12 AM |
