Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position (Fig. 1).
Your battery pack is equipped with a
secondary locking latch to prevent the battery
pack from completely falling out of the handle,
should it become loose due to vibration.
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward. Press the battery pack release button
again and slide the battery pack completely out
of tool housing.
-10-
POCKET CUTS
POCKET/PLUNGE CUTS
The reciprocating saw can be used to make
plunge cuts into softer material, (for example,
wood or light buildi ng mat erials for w alls),
without a starting hole (Fig. 4).
1. Mark the line to be cut clearly on the work.
2. Set the tool with one edge of the footplate
firmly against the material.
3. Place the tip of the blade (not running) on the
line to be cut.
4. Tilt the saw so that the blade clears the work.
5. Squeeze the tr igger switc h and carefully
engage the moving saw blade into the material.
6. After the blade penetrates through the work,
continue sawing along the marked outline.
NOTES:
To make plunge cutting easier, use a heavy
gauge blade, install the blade with the teeth
facing upward, and hold the saw upside down
as shown (Fig. 5).
Do not plunge cut in metal surfaces.
In thic k mate rials and in harde r mate rials,
such as metal, plunge cutting should not be
attempted. Such materials can be cut with the
recip saw only by star ting the cut from the
edge of the material or from a hole drilled all
the wa y thro ugh t he mat erial that is la rge
enough to fit the saw blade.
The use of any accessories
not specified in this manual
may create a hazard.
!
WARNING
INSERTING AND RELEASING BATTERy PACK
FIG. 4
FIG. 5
2610034440 03-14_CRS180 3/27/14 11:45 AM Page 10