BM 1619P06013
Operating Instructions
DEPTH ADJUSTMENT
Disconnect plug from power source. Loosen the depth adjustment lever located in the housing of saw. Hold the foot down with one hand and raise or lower saw by the handle.
Tighten lever at the depth setting desired. Check desired depth (Fig. 3).
Not more than one tooth length of the blade should extend below the material to be cut, for minimum splintering (Fig. 4).
FIG. 3 |
|
| |
CALIBRATED DEPTH | FIG. 4 | ||
| |||
|
| ||
| BRACKET | ||
| DEPTH | ONE TOOTH LENGTH SHOULD |
| ADJUSTMENT | |
| PENETRATE WOOD FOR | |
| LEVER | |
| MINIMUM SPLINTERING | |
| BLADE WRENCH | |
FOOT |
| |
& STORAGE AREA |
|
90° CUTTING ANGLE CHECK
Disconnect plug from power source. Set foot to maximum depth of cut setting. Loosen bevel adjustment lever, set to 0° on quadrant, retighten lever and check for 90° angle between the blade and bottom plane of foot with a square (Fig. 5). Make adjustments by turning the small alignment screw, if necessary.
FIG. 5
BEVEL
ADJUSTMENT 90°
LEVER
ALIGNMENT
SCREW
FOOT
BLADE
BEVEL ADJUSTMENT | FIG. 6 |
Disconnect plug from power source. The foot can be adjusted up to 56° by loosening the bevel adjustment lever at the front of the saw. Align to desired angle on calibrated quadrant. Then tighten bevel adjustment lever (Fig. 6).
Because of the increased amount of blade engagement in the work and decreased stability of the foot, blade binding may occur. Keep the saw steady and the foot firmly on the workpiece.
