Bosch Power Tools manual Leveling Base, Operating Instructions, Introduction, Leveling GPL3T

Leveling Base

The optional leveling base makes it easy to level the GPL3T across its length and its width.

1.Orient the laser tool such that laser end is at the narrow end of the base.

2.Please the laser tool on the base such that it sits between the alignment ridges and that its threaded mount sits over the stud at the center of the base.

3.Level the laser tool lengthwise by rotating the knob nearest to the laser aperture until the bubble is between the two lines on the spirit level.

4.Level the laser tool widthwise by rotating the knob that is furthest away from the laser aperture until the bubble is between the two lines on the spirit level.

Operating Instructions

Introduction:

Congratulations! You have just purchased a time-saving precision laser tool of superior quality. The GPL3T is both precise and easy to use. Simply turn the laser tool on and you have three, perfectly square beams for your level, plumb and square applications. Use the bubble vials to manually level your new GPL3T torpedo laser level.

Turning GPL3T on and off:

To turn laser tool on, turn the knob on the back of the unit clockwise.

To turn laser tool off, turn the knob counter clockwise to the original position.

On/Off

Leveling GPL3T:

The laser tool has three 90˚ beams that can be used to level, plumb and square.

When the laser tool is in the horizontal orientation the bubble in the bubble vial in the middle of the unit must be centered.

When laser tool is in the vertical orientation the bubble in the bubble vial closest to the beams must

be centered.

-5-