Bose 131 manual Installing Your Speakers From The Front Of The Bulkhead

Installing Your Speakers From The Front Of The Bulkhead

B 15

B 16

Remove the perforated speaker cone shields from the enclosure cartons. Insert the tabs of the shields into the speaker ports. This helps protect the speaker cone from potential damage during the installation process.

Install six screws, if possible. You need at least three screws installed and equally spaced.

Note: If you plan to use a screw gun to install the screws, you should first set the gun to its lowest torque setting (do not exceed 12 inch-pounds or

135.84N-cm of torque). If the screw does not seat properly, finish installing the screw at the next highest torque setting, or by hand.

B 17

B 18

Remove the speaker cone shield from the enclosure.

Finally, snap on the grille to the mounting flange. No hardware is needed to secure this part. You are now finished with the assembly. Enjoy your music system!

AM188201_02_V.pdf October 30, 2001 15