![Step 1: Set up the remote control](/images/new-backgrounds/25333/2533331x1.webp)
SYSTEM SETUP
Step 1: Set up the remote control
A.Slide the battery compartment cover off the back of the remote control.
AA (IEC LR6) batteries (4)
Battery compartment cover
B.Install four AA (IEC LR6) batteries, matching the polarity markings (+ and
C.Slide the battery cover back into place.
Step 2: Turn your system on and follow the
A.Press the power button () on the control console to turn on your system.
Because the system is in a low power state when in standby, it takes several seconds to start. When the power light on the control console changes from blinking to steady green, your system is ready to use.
Power light
B.Check that the status indicator on the speaker array is off.
Status
If the Status indicator is blinking orange:
•There is no wireless connection between the speaker array and the Acoustimass® module.
•See the Troubleshooting table in the back of the operating guide and follow the instructions for correcting the problem of “No Sound.”
16 – English