Maintaining Your Lifestyle® 25 System
Changing the house code settings
Each Lifestyle® remote control uses a system of matching house codes to communicate with its corresponding music center. If your remote’s commands ever conflict with those of another nearby Lifestyle® system, you can easily set a new house code for your system and its remote control(s) by following the procedures below.
1.Open the remote control battery cover and locate the miniature switches (Figure 30).
2.To create a new code, change the position of switches 1, 2, 3, or 4 by moving them in the opposite direction from their current settings. Use a paper clip, ball point pen, or similar object.
Note: Do not change switches 5, 6, or 7 at this time. The manufacturer’s standard setting is switch 5 up and switches 6 and 7 down.
3. Replace the battery cover.
Figure 30
Miniature switches for setting house codes and zones
Figure 31
Display confirming an example of house code setting switch 1 up, switches 2, 3, and 4 down
House code switches
ON |
|
|
|
|
|
| K40 |
l | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
4.Lift the music center door.
5.Turn both zones off.
6.Press and hold the STORE key. The display will begin to flash PROGRAM.
7.While you hold the STORE key and the display is flashing, press any key on the remote control.
•The display stops flashing and momentarily shows PROGRAM to confirm recognition of a new house code.
•The display verifies the house code by lighting four rectangles corresponding to the four switch positions (up or down). See the example in Figure 31.
8.Release the STORE key. The system remains off.
9.If you have additional remote controls, change the switches to match those of the first remote control. It is not necessary to repeat steps
Note: To verify your system’s house code, press STORE while the system is off. The display confirms the settings of switches
32 | October 29, 2001 | AM196575_05_V.pdf |
