Setting Up
Mounting your speakers on a wall
CAUTION: Do not mount the brackets on surfaces that are not sturdy enough, or that have hazards concealed behind them, such as electrical wire or plumbing. If you are unsure about install- ing the bracket, contact a qualified professional installer.
CAUTION: Do not hang items from the brackets or speakers. The brackets were designed to support the weight of the speakers only.
Note: See the back pages of this guide for the mounting template and hardware information.
Note: For vertical mounting, mount part A with the hole for screw C at the bottom. Be sure to tighten all screws.
Note: For Stereo Everywhere® speaker performance, horizontal mounting is required.
1.Hold the mounting template in position and mark holes for the mounting hardware. If you plan to feed wires through the wall, mark the speaker wire pilot hole also.
2.Drill holes for the chosen mounting hardware.
3.Mount bracket part A to the wall and mount bracket part B to the rear of the speaker (Figure 8).
4.Secure the speaker with bracket part B to bracket part A using screw C. To adjust the angle, loosen screw C slightly, move the speaker up or down, and retighten screw C.
Figure 8 | A | B |
|
C
AM257528_01_V.pdf | October 26, 2001 | 11 |
