45 of 66
6.0 FreeSpace® 4400 System Setup
5. Click Continue. Your Auto V olume Tracking settings are con-
firmed. If the tracking settings are not correct, click the Can-
cel button, change the settings, and start the setup process
again.
6. Click Continue. All sour ces assigned to the zone are listed in
the window. Yo u are asked to confirm that a source is con-
nected and operating. If the source list is wrong, click the
Cancel button, use the Source Assign control panel to cor-
rect the problem and start the process again.
7. Click Continue to begin the source calibration setup steps.
Wait for the setup steps to be completed.
Programmer’s Note: If you attempt to calibrate a
source that is already calibrated, the dialog box will tell
you that source calibration is being skipped.
When the setup steps are done, you are asked to make vol-
ume adjustments. The maximum output gain should always
be greater than -20 dB for proper Auto Volume operation. If
the maximum output is less than -20 , th e source calibra ti on
procedure might fail. If your system is too loud in this range,
change the loudspeaker taps to a lower setting.