TAB 8 | TAB 7 | TAB 6 | TAB 5 | TAB 4 | TAB 3 | TAB 2 |
English
INSTALLATION
Connecting the speaker
As you connect the wires, be careful to match the polarity of each wire to the proper terminal, as described below. An error here will adversely affect speaker performance.
1.Choose the one wire on the cable end that is marked with a colored collar or other indicator, (which distinguishes it as the positive (+) wire.
2.Notice the red circle on the exposed end of the positive (+) speaker terminal.
3.Compress both ends of the terminal and fully insert the bared tip of the positive wire into the terminal opening.
Avoid inserting any insulated part of the wire.
4.Release pressure on the terminal to capture the wire.
5.Insert the other wire into the other terminal, marked with a black circle on the end to indicate it is negative
CAUTION: Do not allow exposed wires to brush against each other. This could damage your speaker or your receiver/amplifier. Trim any excess wire and reinsert it as necessary.
Positive (+) wire to positive (red) terminal
Finishing the installation
It is important to have all of your equipment ready and within easy reach to complete this procedure.
Securing the speaker
As you lift the speaker, keep the speaker cable above and out of the way to prevent pinching it.
You may notice a security flange, located on the upper edge of the speaker, for use where local building codes require it.
1.Use two hands to hold the edge of the speaker as you guide it into the ceiling hole.
CAUTION: Be sure not to press on the two small drivers seated on the face of the speaker.
Security flange
CAUTION: Be careful not to damage or remove any of the foam gasket material along the edge of the speaker. This gasket is important to the operation of the speaker.
8
