Bose AM262838_00_V manual Antenna grounding

Important Safety Instructions

18.Use proper power sources – Plug the product into a proper power source, as described in the operating instructions or as marked on the product.

19.Avoid power lines – Use extreme care when installing an outside antenna system to keep from touching power lines or circuits, as contact with them may be fatal. Do not install external antennas near overhead power lines or other electric light or power circuits, nor where an antenna can fall into such circuits or power lines.

20.Ground all outdoor antennas – If an external antenna or cable system is connected to this product, be sure the antenna or cable system is grounded. This will provide some protection against voltage surges and built-up static charges.

Section 810 of the National Electrical Code ANSI/ NFPA No. 70 provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the ground electrode. Refer to the antenna grounding illustration on this page.

Antenna grounding

Example of antenna grounding as per National Electrical Code, ANSI/NFPA 70.

Antenna lead in wire

Ground clamp	Antenna discharge unit
	(NEC Section 810-20)
Electric service	Grounding conductors
	(NEC Section 810-21)

equipment

Ground clamps

Power service grounding electrode system

(NEC ART 250, Part H)

Note to CATV system installer

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC (of USA) that provides guidelines for proper grounding. In particu- lar, it specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as is practical.

©2001 Bose Corporation,

The Mountain, Framingham, MA

01701-9168 USA

255805 AM Rev.00 JN10494

b December 20, 2001 AM262838_00_V.pdf