8.0 E4 System Troubleshooting
8.2.4 Input clipping
If clipping is occurring at the input of an amplifier channel, the source LED will blink red.
8.2.6 No STANDBY and SYSTEM indicators
STANDY & SYSTEM LEDs are off - AC power is on
|
|
| AMP OUTPUTS |
|
| SYSTEM | ||||||||
|
|
|
|
| ||||||||||
1 | 2 | 3 |
|
| 4 | STATUS | ||||||||
|
|
|
|
|
|
|
|
|
|
|
| STANDBY | ||
|
|
|
|
|
|
|
|
|
|
|
| |||
|
| AUDIO SOURCES |
|
|
| |||||||||
|
|
| DIRECT |
|
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
| |||
1 | 2 | 3 |
|
| 4 | INPUT |
|
|
If this fault occurs:
•Reduce the output gain of the source, or
•Using the Installer™ software, reduce the input gain for the channel that is clipping.
8.2.5 Direct input is active
If the DIRECT INPUT LED is red:
•Check that the DIRECT INPUT/CONTROL contact closure is in the closed position.
•Check the device to which this input is connected.
|
|
| AMP OUTPUTS |
|
| SYSTEM | ||||||||
|
|
|
|
| ||||||||||
1 | 2 | 3 |
|
| 4 | STATUS | ||||||||
|
|
|
|
|
|
|
|
|
|
|
| STANDBY | ||
|
| AUDIO SOURCES |
|
|
| |||||||||
|
|
| DIRECT |
|
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
| |||
1 | 2 | 3 |
|
| 4 | INPUT |
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Is E4 unit | No | ||
plugged into an |
|
| |
|
| ||
AC source? |
|
| |
| Yes |
|
|
|
|
| |
|
|
|
|
Is the E4 | No | ||
POWER switch |
|
| |
|
| ||
set to ON? |
|
| |
| Yes |
|
|
|
|
| |
|
|
|
|
Is STANDBY | Yes | ||
|
| ||
indicator on? |
|
| |
|
| ||
| No |
|
|
|
|
| |
|
|
|
|
Yes
Is SYSTEM STATUS
indicator red?
No
Is the unit properly | No | |
configured for the line |
| |
| ||
voltage? |
| |
| Yes |
|
|
| |
|
|
|
Plug the E4 unit into an AC receptacle.
Set E4 POWER switch to ON.
Press the STANDBY switch on the E4 front panel.
•Connect your PC to the E4 unit and read the Error Log.
•Check the results of the Power On self test (POST).
•Use the POST troubleshooting chart for course of action.
•Set E4 POWER switch to OFF.
•Verify that E4 unit is configured for the correct AC line voltage.
•Verify that the fuse is good.
•Verify that the AC receptacle is live.
•Set POWER switch to ON.
Contact Bose
Customer Service.