English

Dansk

Deutsch

Español

Français

Italiano

Nederlands

Svenska

INTRODUCTION

What distinguishes the two units

The connection panel on each unit identifies it by name: TRANSMITTER or RECEIVER. Two Bose® link jacks and a Channel button further distinguish the transmitter.

For compatibility, the two units have a matching Setup Code, set at the factory with both switches in the “down” position (Figure 2). A Status LED lights when each unit is plugged in and the two units are communicating.

Figure 2

Connection

Transmitter

Receiver

panels on the two

 

 

units

 

 

Bose® link jacks

Channel switch

Bose link jack

Status LED

Note: For information on the meaning of the different Status LED lights, refer to “Check the indicators and settings” on page 9.

Choosing a place for each unit

Place the transmitter in the same room with the LIFESTYLE® system media center. Place the receiver in the same room with your Bose® link expansion product.

Note: Use of the audio link with products that are not Bose link-compatible requires an adapter cable. For further information, refer to “Instructions for non-Bose or older Bose® products” on page 8.

Considerations for positioning:

Place each unit upright with all feet flat on a level surface, such as a floor, table, or shelf.

Do not tip either unit on its side.

Place each unit within 2 meters (7 feet) of the product to which it is connected (using the supplied Bose link A cable).

Keep the two units within 23 meters (75 feet) of each other.

Be aware that the strongest signal direction is above and around, not below,  the transmitter.

5

Page 5
Image 5
Bose Link AL8 manual Choosing a place for each unit, What distinguishes the two units