Svenska

Nederlands

Italiano

Français

Español

Deutsch

Dansk

English

SETUP

Instructions for non-Bose or older Bose® products

Figure 7

Connections using the adapter cable

The Bose® link AL8 Homewide Wireless Audio Link also works with some products that are not Bose link-compatible.

You can use non-Bose products in the following ways:

A tuner/receiver as a sound source connected to the transmitter or in an expansion room connected to the receiver

Powered speakers connected to the receiver

You can use older Bose products as follows:

Powered speakers, a radio, or system with its own volume and on/off controls and line- level female RCA input jacks connected to the receiver

Any of the above products require the use of an RCA to DIN adapter cable for connecting to the transmitter, the receiver, or both. An adapter kit, which contains two of these cables, is available from Bose.

Note: To order the adapter kit, contact Bose and request Part Number 285320-207. For Bose contact information, refer to the address sheet included in the carton.

To use an adapter cable:

The RCA connectors are color-coded, red for right and white for left.

1.Insert the adapter cable DIN connector into the Bose® link jack on the transmitter (INPUT) or receiver (OUTPUT) jack, as appropriate.

2.Insert the adapter cable RCA connectors into the Audio Out jack on the connection panel of the audio source or the Audio In jack on the expansion room product. Match left to left and right to right.

Source Product

Expansion Room Product

Audio Output

Audio Input

L

L





R

R

Transmitter

Receiver

Bose® link

Bose® link

INPUT

OUTPUT

Adapter cable

Adapter cable

3.Complete the connections using the power pack:

Insert the small plug on the power pack cable into the AC Power jack on the transmitter or receiver.

Insert the small connector end of the power cord into the jack on the power pack. Plug the other end of the cord into an AC (mains) wall outlet. The Status LED lights to verify this power connection.

Note: For information on the meaning of the different Status LED lights, refer to “Check the indicators and settings” on page 9.

In the room where your AR1 receiver is connected using the adapter cable, be sure to set your Bose link remote or PERSONAL® music center II for use in Room “O.”

8

Page 8
Image 8
Bose Link AL8 manual Instructions for non-Bose or older Bose products, To use an adapter cable