INTRODUCTION
4
EnglishDeutschEspañolFrançaisItalianoNederlandsSvenska Dansk
Connection panel
The rear panel provides all input/output connections.
Figure 3
T1 connector
panel
1. IN – Analog input channels 1-3. Accepts XLR balanced cables for microphones, or ¼" TRS balanced or TS
unbalanced cables for high-impedance inputs such as guitars.
2. Preamp OUT – Preamp outputs for channels 1-3. Accepts ¼" TRS balanced or TS unbalanced cables.
3. Line IN – Analog input channels 4/5. Accepts ¼" TRS balanced or TS unbalanced cables for line-level inputs.
Can be used for stereo input signals.
4. Aux Output – User-definable analog output. Can be configured for a pre-fader, post-EQ, and effects, or post-
fader output. Accepts ¼" TRS balanced or TS unbalanced cables.
5. Master Output – User-definable analog output. Can be configured for a pre- or post-Master volume analog
output. Accepts ¼" TRS balanced or TS unbalanced cables.
6. USB port – A USB interface that allows you to connect the T1 to your computer. This feature enables you to
stream audio to/from your computer, update the T1, and back up performance scenes.
7. Power switch – Turns the T1 audio engine on or off.
8. Ton eM at ch TM port – A digital output used by the L1TM model II system. Also delivers power to the T1
audio engine from the L1 model II power stand. Accepts the included ToneMatchTM cable.
CAUTION: Although the ToneMatch port accepts a standard RJ-45 connector, DO NOT connect the T1 to a computer
or phone network.
2
3
6
5
7
1
4
8