11
SYSTEM SETUP
SvenskaItalianoFrançaisEspañolDeutschDanskEnglish Nederlands
Connecting the T1 to an L1TM model II power stand
1. Make sure the power stand Power switch is OFF, the T1 power switch is OFF, and the T1 Master volume
control is set to 0.
2. Plug one end of the ToneMatchTM cable into the ToneMatchTM port ( ) on the T1. Plug the other end of the
Ton e M a t c h TM cable into the Ton eM atc hTM port on the power stand.
3. Turn on the T1 audio engine and then turn on the L1 model II power stand.
4. Connect your instruments and adjust levels. Refer to “Optimizing input gain and output volume” on page 16.
Figure 10
L1TM model II
connections to
a T1
Power / Fault
ToneMatch
cable Hook-and-loop strap
hanging excess cable
on the carriage