Bose VCS-30, VCS-10 Connect the speakers, Choosing speaker cord, Be sure to use the cord properly

Models: VCS-30 VCS-10

1 17
Download 17 pages 13.71 Kb
Page 8
Image 8
Connect the speakers

Setting Up

Connect the speakers

Choosing speaker cord CAUTION: Before making any connections, turn off your receiver or amplifier and unplug it from the AC power (mains) outlet. Not doing so may result in damage to your system.

Be sure to use the cord properly CAUTION: Never use broken or frayed wiring, which can result in damage to your components.

Manual background Note: Before running speaker cord through a wall or under a floor, check your local building code requirements and safety regula- tions. You may want to contact an electrical installer for this infor- mation.

If your receiver’s center channel is not amplified, you must con- nect an amplifier to the receiver. Use an RCA cable to connect the center channel RCA-type output on the receiver to the RCA-type input on the amplifier. The speaker will then connect directly to the amplifier instead of to the receiver.

Choosing speaker cord

Be sure to use the proper gauge (thickness) of speaker cord. Standard zip cord (2-conductor, 18-gauge wire found at electrical and hardware stores) works for most applications. If your speak- ers will be more than 30 feet (9 m) from the receiver or amplifier, see the following table, or check with your authorized Bose dealer.

Gauge*

Length*

18

(0.75 mm2)

30 ft (9 m) maximum

16

(1.5 mm2)

45 ft (14 m) maximum

14

(2.0 mm2)

70 ft (21 m) maximum

* Based on a maximum frequency response deviation of ±0.5dB.

At the ends of each cord, strip approximately 12 inch (12 mm) of insulation from both wires. Twist the bare end of each wire, so loose strands will not touch across terminals.

Be sure to use the cord properly

Speaker cord consists of two insulated wires. The insulation around one wire is marked (striped, collared, or ribbed). This marked wire is always positive (+). The plain wire is always nega- tive (–). These wires correspond to the red (+) and black (–) termi- nals on the speaker and the receiver or amplifier.

Manual background Note: It is sometimes difficult to distinguish wire markings. Inspect both wires carefully.

8

Page 8
Image 8
Bose VCS-30, VCS-10 manual Connect the speakers, Choosing speaker cord, Be sure to use the cord properly, Setting Up