Bose Wave Radio manual Unpack the carton see Figure, Install the batteries

Setting Up

Unpack the carton (see Figure 1)

Carefully unpack the carton. Do not attempt to use the Wave® radio if any part appears dam- aged. Instead, repack the carton and notify Bose® or your authorized Bose dealer immediately.

Place the Wave® radio on a table or other flat surface. Locate the FM and AM antennas, the power cord, and the AA batteries.

Wave®		AA batteries
radio
		Remote control
Power cord	Lithium
	battery
FM antenna	Peel-and-
	stick tape
	AM antenna clip	AM loop antenna

Figure 1

What comes with your Wave® radio.

•One (1) Wave® radio

•One (1) power cord

•Three (3) AA batteries

•One (1) FM antenna

•One (1) AM antenna

•One (1) AM antenna clip

•One (1) peel-and-stick tape

•One (1) remote control

•One (1) lithium battery

Install the batteries

The Wave® radio’s three AA batteries maintain its memory and backup alarm system for up to a week during a power failure, or while the radio is unplugged. The batteries will not power the radio or light the display. Operating without batteries leaves the memory unprotected, but will not harm the radio. Use only 1.5V AA alkaline batteries (IEC-R6 in Europe), available at many retail stores.

1. Carefully turn your Wave® radio	+ – +
upside down (avoid scratching
its top).

2.Locate the battery compart-

ment on the bottom (see Figure 2).

3.Press the arrow on the cover to

slide the compartment open.

Figure 2

Match the + and – symbols on the batteries to the marks inside the compartment.

4.Place the batteries inside, matching the + and – symbols with the symbols inside the compartment.

5.Slide the cover back into place and turn the radio right side up.

172087 50W 60HZ-50 120V~AC

OUT VARIABLE
	IN AUX
L	R

AM149204_02_V.pdf January 7, 2002 5