Setting Up
Connect the power cord and antennas
Find the jacks on the back of your radio (see Figure 3). Unwind all cords.
Connect the power cord
1.Plug the small end of the power cord into the power jack.
2.Plug the other end of the power cord into an electric outlet. The display panel should light up.
Note:
The time display will begin to flash after power is connected. Press the CLOCK SET key once to stop the flashing.
Connect the antennas
1. Plug the FM antenna into the “FM 75Ω External” connector.
2.Plug the AM antenna into the “AM LOOP” jack.
3.Straighten both antennas. Move the AM loop and ends of the FM antenna as far as possible away from the radio.
4.Use the clip and
Note:
A second FM antenna is built into the power cord. For best reception, adjust the antenna by moving the power cord.
R | L |
|
AUX IN |
|
|
| 120V~AC | AM |
| ||
| 172087 | LOOP |
VARIABLE OUT |
|
|
|
| |
|
| stick tape |
|
| clip |
Figure 3
Plug the antennas and power cord into their jacks.
6 | January 7, 2002 | AM149204_02_V.pdf |
