INSTRUCTIONS
1. PWR/SEL/VOL (power/mode select/volume button)
After the unit getsconnected to the power supply, short press the button to turn
The unit on,long press it to turn the unit off.Repeatedly short press SEL button to select your desired mode in the following sequence:
VOL→BASS→TRE→BAL→FAD→LOUD→EQ→ST→BEEP→AREA
(USA: America/EUR: Europe)
Work with VOL button, rotate it to make adjustment.
Rotate the button to adjust the volume level, the change value of volume level shall be displayed on LCD screen.
2. BAND/AST (band switch/station auto scan &store)
Under radio status, press the button to shift band cyclically as shown below, the actual shift is the standard.
1Fm1→Fm2→Fm3→Am1→Am2→Fm1;
2Fm1→Fm2→Fm3→Mw1→Mw2→Fm1;
Hold AST button for 3 seconds to automatically scan station in the whole band and store station. Press the number button to listen to stored stations.
During reading a card, long press the button to display TRK SCH to search for track. Work with VOL+/- to make adjustment and press SEL for confirmation. If no adjustment is made within 3 seconds, system automatically skips from units to tens and hundreds. During adjustment, press BND to move back to the previous digit level. Short press this button to browse ID3 information.
3. MODE/CLOCK (mode shift/clock time display & setup)
When the power is on, each time the button is pressed, the mode switches
Between RADIO/USB/SD(MMC)/AUX.
Note: When there is no USB/SD card connected to the unit, system shall
automatically skip the unconnnected modes.
Setting the clock:
Press and hold the MODE/CLK until the clock appears. Press and hold the MODE/CLK until the clock starts to blink. Using the volume knob set the hour, then press the volume knob to set the minutes.
