Boss Audio Systems 625UAB user manual ST Button, Loud Button, LOC Button, Radio Operation

4)Press and hold CLEAR button to cancel all numbers entered if necessary.

5)Briefly press TEL to start dialling. The talking time will appear on LCD if dialling is successful and it is received.

C) Redial

Press TEL button on remote control twice or press 6DIR+ button on main unit, it will show the last dialled phone number on LCD and dial the number directly.

4. Accept/ Reject/ End Call

A)During ringing, press TEL button to accept the call.

B)During ringing, press CLEAR button to reject the call.

C)During talking, press CLEAR button to end the call.

Note:

During ringing, PHONE appears and then the phone number. During talking, talking time appears.

5.Talking volume level setting

While talking, use volume control to adjust volume level, but this volume level can not be saved.

6.Dialling or receiving calls while the unit is in sleep mode

When the car radio is in standby mode (Acc on and Power off), when dialling or receiving a call, the car radio will power on automatically. After the call is completed, the radio will revert to standby mode.

7.To transfer the audio of a file played by Mobile Phone to the Car Audio Player If the mobile phone supports A2DP and could play audio files, when the Mobile Phone plays an audio file(For some Mobile Phones, you must first select Play by BT ), the playback will be transferred to the Car Audio Player.

In A2DP mode, if the Blue tooth device of the Mobile Phone supports AVRCP, the functions of the >>, << and PLAY/PAUSE buttons are the same as one in media mode(no fast forward/backward functions for the >>/<< buttons). The other buttons normally available in media mode are not available.

7. ST BUTTON

In FM mode, press the ST button briefly on remote control to select stereo or mono sound mode.

8. LOUD BUTTON

When press shortly, the LOUD mode is turned on, its to enhance the bass sound effect when the volume level is low. Press again to cancel the loudness effect.

9.LOC BUTTON

Radio station search mode is divided by this LO/DX switch, this button can be used to control an attenuator in the tuner during search. The detecting level of seek, scan, auto-memory will be reduced as much as the attenuated level of the tuner. In radio mode, press the LOC button to change local reception or distance reception. (Note: This button is only for FM reception. In AM mode, LOC is void.)

10.To remove front control panel

Press RELEASE button to release front control panel from unit chassis, then you can remove it from unit chassis.

When front control panel is removed, the LED indicator on front cabinet flashes.

11. To reset unit

Before operating the unit for the first time, or after replacing the car battery or changing the connections. You must reset the unit.

(To reset the unit, remove the front control panel, then press RESET button and hold for more than 8 seconds with a cuspidal object.)

Note: Press and hold 1/> button for more than 8 seconds can reset the unit. This operation will erase some stored contents and restore the unit to its original factory settings.

RADIO OPERATION:

1.To select radio band

Press BAND or BND button briefly and repeatedly to select a desired radio band in sequence and circulation as follows: -->FM1-->FM2-->FM3-->AM1(MW1)-->AM2(MW2)--> .

2.To search for radio station manually or automatically

Press >> or << button briefly to manual tune up/down for your desired radio stations step by step.

Press and hold >> or << button for 0.5 seconds, to automatically tune up/down for a radio station of strong signal.

You can also press SCN button on remote control to automatically tune up for a radio station of strong signal.

Page 7	Page 4
PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com