INSTALLATION
3.Press the release button to remove the front panel.
4.Lift the top of the outer trim ring then pull it out to remove it.
5.Insert both of the supplied keys into the slots at the middle left and right sides of the unit, then pull the unit out of the dashboard.
To fasten the unit to the factory radio mounting brackets.
Align the screw holes on the bracket with the screw holes on the unit, and then tighten the screws (5x5mm) on each side.
Note: the outer trim ring, sleeve and the metal strap are not used for method B installation.
DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota, follow these mounting instructions.
Use the screw holes marked T (Toyota), N (Nissan) located on both sides of the unit to fasten the unit to the factory radio mounting brackets supplied with your vehicle.
Side View showing
Screw Holes marked
T, N
Screw
Factory Radio
Mounting Bracket
Screw 
Dashboard or Console
8
