Boss Audio Systems ME-20 Calling Up and Using Saved Sounds (Patch Change)

25
Saving and Calling Up Tones (Memory Mode)
Calling Up and Using Saved Sounds (Patch Change)
To switch patches, use [ ] [ ] and the number pedals (1–3).
* When you initially switch to Memory mode after turning on the power, Bank 1, Number 1
is always selected.
fig.ME-20-patch-change.eps_35
Switching Numbers
When a number pedal (1) is pressed, the
pedal indicator (2) lights up, the patch
with that number in the currently
selected bank is called up, and the
sound is switched instantly.
fig.ME-20-bank-change.eps_35
Switching Banks
The bank is switched each time [ ] [ ]
(1) is pressed, and the currently selected
bank flashes in the display (2); sounds
are not yet switched at this point.
* With the ME-20 in this state, pressing any
of the number pedals (3) instantly switches
the sound to the sound of the patch assigned
to the currently selected bank/number.
You can switch banks with the number pedals.
In Memory mode, if you continue
depressing the number pedal for the currently selected patch for two seconds, the pedal
indicator flashes, and the functions of the number pedals change as shown below.
Number Pedal 1: Bank
Number Pedal 2: Bank
Number Pedal 3: Restores original pedal functions
You can switch banks using a footswitch pedal. For more information, refer to
“Using Footswitch Pedals” (p. 27).
(1)
(2)
(3)
(1) (2)
ME-20_e.book 25ページ ２００７年９月１０日 月曜日 午後６時２２分