26
Saving and Calling Up Tones (Memory Mode)
Changing Patch Settings (Patch Edit Mode) In Memory mode, switching effects on or off or adjusting NS THRESHOLD is not possible. To
make these changes, you put the unit in Patch Edit mode.
fig.ME-20-patch-edit.eps_55
1.
Call up to the patch whose settings you want to edit (p. 25).
2.
Press [EDIT/EXIT].
“Ed” appears in the display and the MEMORY indicator starts to flash, indicating
that the unit is now in Patch Edit mode.
As in Manual mode, with the ME-20 in this state, the number pedals switch the
effects on and off, while [ ] [ ] control NS THRESHOLD, allowing you to set all
the parameters.
3.
Use the knobs, pedals, and buttons to change settings as desired.
4.
Press [EDIT/EXIT] to return to Memory mode.
5.
If you want to save your new settings, carry out the Write procedure (p. 24).
Changed settings are not saved until the Write procedure is performed. Switching
to a different patch before saving a patch causes its changed content to be lost, so
the next time the patch is selected, its previous settings are called up.
1
1
2,4
5
ME-20_e.book 26ページ ２００７年９月１０日 月曜日 午後６時２２分