Specifications
Supply voltage | : 12V |
| |
Current consumption | : Less than 10A |
| |
Audio Signal Output | : 2ch line out |
| |
Characteristics | : (1) | Frequency Response: | |
| (2) | S/N Ratio: | 50 dB(JIS) |
| (Europe) | (U.S.A.) |
Frequency Coverage: | FM | FM |
87.5 to 108Mhz | 87.5 to 107.9Mhz | |
IF | 10.7Mhz | 10.7Mhz |
Sensitivity (S/N = 30dB) : | 20dBu | 20dBu |
Frequency Coverage: | AM | AM |
522 to 1620Khz | 530 to 1710Khz | |
IF | 450Khz | 450Khz |
Sensitivity (S/N = 20dB) : | 45dBu | 45dBu |
NOTE:
Specifications and design are subject to modification, without notice, due to improvements in technology.
Page 9
1)TA SEEK/TA ALARM:
TA SEEK mode: when newly tuned station does not receive TP information for 5 seconds, the radio retunes to next station which has a different PI to the last station, but has the TP information.
When TP information gets lost at the current station for retune time which is set by RETUNE SHORT(90 seconds) or RETUNE LONG(150 seconds), the radio starts to retune to next same PI station. When same PI station does not receive in 1 cyclic search, the radio retunes to next station with TP information.
TA ALARM mode: when this mode is selected, any automatic retune mode is not activated. Only double beep sound(ALARM) will be heard.
When newly tuned station does not have TP information for 5 seconds, beeps are sounded.
When TP information gets lost at the current station for retune time, the beep sound will be heard.
When newly tuned station has no RDS signal, PI SEEK is suppressed .
2)PI SOUND/ PI MUTE:
PI SOUND mode: if a car cruises between buildings that could cause reflecting signals, a phenomenon may occur, due to different PI codes being received from the same AF source. when different PI sounds (DIP) are heard occassionally, this will happen for less than 1 second.
PI MUTE mode: under above same situation, a mute sound will be heard for less than1second.
3)RETUNE L / RETUNE S:
The initial time of automatic TA search or PI SEARCH mode is selected.
When PI information is not received for retune interval , the radio starts to retune to next same PI station.
When same PI station does not receive 1 cyclic search, the radio goes to last station and waits for
RETUNE L mode: selected as 150 seconds.
RETUNE S mode: selected as 90 seconds.
4)MASK DPI/MASK ALL:
MASK DPI mode: masks only the AF which has different PI.
MASK ALL mode: masks the AF which has different PI and NO RDS signal with high
field strength.
5)BEEP ON/BEEP OFF
BEEP ON mode: The beep is generated when any key is pressed.
BEEP OFF mode: The beep sound is disabled.
6)VOL LAST/VOL DEFA
VOL LAST: The radio switches on at the actual volume it had when it was last switched off.
VOL DEFA: After pressing SEL button, AVOL will be displayed. Then you can
7)CLK ON/OFF
CLK ON: Clock will always show on the display when power off.
CLK OFF: Clock will disappear on the display when power off.
5.LCD Display
6.MODE BUTTON
Press it to select RADIO, CARD(after inserting MMC/SD card), USB(after inserting USB stick) ,IPOD (after connect IPOD cable) and AUX mode.
Page 2
PDF created with FinePrint pdfFactory Pro trial version http://www.pdffactory.com
