6.BASIC OPERATIONS
1)PANEL RELEASE BUTTON (REL)
Press this button to remove the control panel.
12)POWER ON/OFF BUTTON
Press this button to turn on or off the power.
5)DISPLAY BUTTON (DISP)
Press this button briefly, the LCD will display the clock for about 2 seconds, then return to previous display mode.
Clock Adjustment
Under clock display mode, press DISP button until the LCD flashes, press Tuning Up Button to adjust hour and Tuning Down Button to adjust minute.
16) SOURCE BUTTON (SOURCE)
Press this button to select different source, sequence as follow:
A)Tuner mode (Radio)
B)CDP / MP3 (only if a CD or MP3 disc is inserted)
C)USB (only if a USB drive is inserted)
D)SD / MMC (Only if a SD or MMC card is inserted)
E)AUX IN (Only if this unit with this features)
MODE PRIORITY
Whenever a USB or SD/MMC is being inserted, unit will automatically switch to USB or SD/MMC mode, does not matter the unit is currently in what source.
When in USB or SD / MMC source, if the USB or SD / MMC is being removed, unit will automatically switch to radio source.
SUB-WOOFER ON/OFF
Press SOURCE button for more than 3 seconds to activate or turn off the
19) FRONT (AND REAR PANEL) AUXILIARY INPUT JACKS
This unit features AUX IN line input jacks on both the front (headphone type) and rear (RCA type) panels.
PLEASE NOTE:
These two inputs cannot be used simultaneously. If you have a source unit plugged into the rear panel jack and wish to listen to a portable device (such as an MP3 player) by using the front panel jack, be sure to power off the unit plugged into the rear unit to
avoid interference. | 1 | Left Audio |
2 Right Audio | ||
Similarly, if you have a device plugged into the front | 3 | Ground |
|
| |
panel jack and wish to listen to the unit plugged into
the rear panel, be sure to turn off the front panel | 3.5mm Audio In Cable (not included) |
| |
device. |
|
To select either the front or rear AUX IN device as a listening source, press the SOURCE button to select AUX mode. To cancel AUX IN listening, press SOURCE again.
RESET BUTTON
The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a ballpoint pen or metal object will activate it. The reset button is to be activated for the following reasons:
Initial installation of the unit when all wiring is completed.
All the function buttons do not operate.
Error symbol on the display.
Note: If the unit cannot function normally after reseting, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control panel.
7
