Bostitch BTFP71917 manual Maintenance Checklist, Maintenance Benefit Procedure Service Interval

Maintenance Checklist

Maintenance	Benefit	Procedure	Service Interval
Inspect trigger performance	Ensure trigger system is in	Refer to Tool Operation	Daily
	proper working order	Check section in this manual
Drain condensation from air	Prevents accumlation of	Open drain cock on tanks	Daily
compressor tanks and air	moisture that can impede tool	and air filters and drain all
filters daily or after each use.	performace	condensate
Clean magazine assembly	Prevents accumlation of	Blow clean with compressed air	Daily
	debris that could cause a jam
Clean nose, door, and	Prevents accumulation of	Blow clean with compressed air	Daily
contact arm area	debris that could cause a jam
	or malfunction
Ensure all fasteners remain	Prevent loose parts	Tighten all fasteners with	Weekly
tight		appropriately sized hex
		wrench
Check/clean air inlet air filter	Maintains proper air flow to	Remove end cap and use	25,000 Fasteners, or monthly
	engine for peak performance.	compressed air blow gun to	- if used in dusty location
		blow filter clean. Replace filter
		as required.
Replace no-mar tip	Prevents marks in softwood	Remove worn no-mar tip and	25,000 Fasteners
	applications	replace with a new tip (a spare tip
		is located on the magazine)
Replace piston/driver	Maintains consistent drive	Refer to replacement part kit	150,000 Fasteners
assembly	quality	instructions
Replace O-rings	Maintains engine for peak	Refer to replacement part kit	250,000 Fasteners
	performance	instructions
Replace bumper	Maintains engine for peak	Refer to replacement part kit	250,000 Fasteners
	performance	instructions
Replace headvalve	Maintains engine for peak	Refer to replacement part kit	250,000 Fasteners
	performance	instructions
Replace engine cylinder	Maintains engine for peak	Refer to replacement part kit	500,000 Fasteners
	performance	instructions

-14-