-3-
SAFETY INSTRUCTIONS
EYE PROTECTIONwhich conforms to ANSI specifications and provides protection
against flying particles both from the FRONT and SIDE should ALWAYS be worn
by the operator and others in the work area when loading,operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris,
which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American National
Standards Institute,ANSI Z87.1-1989 and provide both frontal and side protection.
NOTE: Non-side shielded spectacles and face shields alone do not provide ade-
quate protection.
CAUTION: ADDITIONAL SAFETY PROTECTION will be required in some environ-
ments.For example, the working area may include exposure to noise level which can
lead to hearing damage.The employer and user must ensure that any necessary
hearing protection is provided and used by the operator and others in the work area.
Some environments will require the use of head protection equipment. When
required, the employer and user must ensure that head protection conforming to
ANSI Z89.1 1986 is used.
AIR SUPPLY AND CONNECTIONS
Do not use oxygen,combustible gases, or bottled gases as a power source for this
tool as tool may explode,possibly causing injury.
Do not use supply sources which can potentially exceed 200 P.S.I.G.as tool may
burst,possibly causing injury.
The connector on the tool must not hold pressure when air supply is disconnect-
ed. If a wrong fitting is used, the tool can remain charged with air after discon-
necting and thus will be able to drive a fastener even after the air line is discon-
nected possibly causing injury.
Do not pull trigger or depress contact arm while connected to the air supply as the
tool may cycle,possibly causing injury.
Always disconnect air supply:1.) Before making adjustments;2.) When servicing the
tool;3.) When clearing a jam; 4.) When tool is not in use;5.) When moving to a dif-
ferent work area,as accidental actuation may occur, possibly causing injury.
LOADING TOOL
When loading tool: 1.) Never place a hand or any part of body in fastener dis-
charge area of tool; 2.) Never point tool at anyone; 3.) Do not pull the trigger or
depress the trip as accidental actuation may occur,possibly causing injury.
OPERATION
Always handle the tool with care: 1.) Never engage in horseplay; 2.) Never pull
the trigger unless nose is directed toward the work; 3.) Keep others a safe dis-
tance from the tool while tool is in operation as accidental actuation may occur,
possibly causing injury.
The operator must not hold the trigger pulled on contact arm tools except dur-
ing fastening operation as serious injury could result if the trip accidentally con-
tacted someone or something,causing the tool to cycle.
Keep hands and body away from the discharge area of the tool. A contact arm tool
may bounce from the recoil of driving a fastener and an unwanted second fasten-
er may be driven possibly causing injury.
Check operation of the contact arm mechanism frequently. Do not use the tool if
the arm is not working correctly as accidental driving of a fastener may result. Do
not interfere with the proper operation of the contact arm mechanism.
Do not drive fasteners on top of other fasteners or with the tool at an overly steep
angle as this may cause deflection of fasteners which could cause injury.
Do not drive fasteners close to the edge of the work piece as the wood may split,
allowing the fastener to be deflected possibly causing injury.
MAINTAINING THE TOOL
When working on air tools note the warnings in this manual and use extra care
when evaluating problem tools.