Boston Acoustics 2 Using the Bravo II on a Flat Surface, Mounting the Bravo, Identify the Bracket

Using the Bravo II on a Flat Surface

The Bravo II can be used on a flat surface, such as a table, shelf or the floor. For horizontal placement that angles up at 45º, both corner fillers must be used and the bracket must be removed. For untilted horizontal placement, the rear stand must be used with the mounting bracket attached (see “Mount the Speaker to the Bracket” and the “Rear Stand Installation Instructions” found on page 6. For vertical applications mount the four supplied rubber feet to the bottom of the speaker. Attach two of the supplied self-adhesive rubber feet so that its edge contacts the back edge of the cabinet. Apply two more self-adhesive rubber feet to the recesses at the front of the cabinet.

filler cap removed

bracket removed

self-adhesive rubber feet applied

corner fillers facing in

bracket removed

Vertical Placement Horizontal Placement–Angled Up

Mounting the Bravo II

Identify the Bracket

In its packing material, the Bravo II’s mounting bracket is fitted into the back of the speaker. Remove the tape that is temporarily holding the bracket to the speaker, and then pull the bracket away from the back of the speaker. Determine how the Bravo II is to be mounted to the wall or ceiling. It can be mounted either horizontally or vertically, either on an open section of wall, or where two or three room surfaces meet. Refer to the illustration here to determine what screw holes on the Bravo II bracket should be used for your application.

NOTE: The large rectangular hole in the middle of the bracket will fit a single gang electrical outlet to route the speak- er wire through a conduit.

single gang electric outlet opening

angle/corner mounting holes (4) 2 per side

flat mounting holes (4) 2 per side

speaker-to-bracket mounting holes (2) 1 per side

single gang electrical box mounting holes

speaker cable run holes (2)

on top and bottom

4