![](/images/new-backgrounds/1181918/18191821x1.webp)
Tuning The Amplifier - Front Speakers and Subwoofer(s)
4) Front Crossover Control Cont.
Slowly rotate the input sensitivity control clockwise until maximum undistorted playing level is heard from the speakers. Listen closely for bottoming from the speakers. If detected, rotate the input sensitivity control counterclockwise until it is eliminated. Slowly rotate the highpass crossover control counterclockwise while listening for bottoming. You are lowering the crossover point, which means that more bass signal is being sent to the speakers. If bottoming is detected, rotate the input sensitivity control counterclockwise until it is eliminated and/or rotate the Highpass crossover control clockwise to raise the crossover point.
5) Rear Crossover Control
Move the selector switch to “LP” (refer to the diagram on page 3). In this setting, lowpass signal is sent to the speaker outputs. Experiment with the crossover point settings while the subwoofer is active. A higher setting will increase the perceived output, and a lower setting will make the bass response more omnidirectional.
6) Q-Tune™ Control
Once the crossover point has been determined, you may choose to use
7) Optional GTA-RSL Control
The optional remote level control
Note; If using the
fuse
Tuning The Amplifier - GTA-504
Connection Diagram: |
|
h Front Speakers and a Subwoofer | 11 |
Lowpass Rear w/ |